Service manual

C762, C764, C764i Stairclimber
Page 56
Note:
Take care not to pinch the cables when you perform the next step.
15. Push the power entry module into the climber. Install the screws that secure the power entry
module to the climber frame.
16. Install the screws that secure the left cover to the climber frame.
17. Tighten the fastener that secures the top of the left cover to the climber frame.
18. Position the front cover enclosure strip over the gap created by the right and left covers.
Press the strip along its length until the top of the enclosure strip lies next to the cover
surface. Repeat this step for the back cover enclosure strip.
19. If you are installing a new upper ribbon cable on the climber...
THEN... OTHERWISE...
Continue with the next step. Skip to Step 30.
Removing the Upper Ribbon Cable
20. Remove the screws that secure the display housing to the display base plate.
21. Push each set of tabs toward the edges of the base plate as you lift the display housing.
Note:
Turn over the display housing and support it on the display base plate while you perform the
following steps.
22. Disconnect the upper ribbon cable from the upper PCA. Do not pull the cable out of the
frame upright at this time. Set the display housing aside.
Replacing the Upper Ribbon Cable
23. Tape one end of the new upper ribbon cable to the lower end of the original upper ribbon
cable.
24. Pull the original upper ribbon cable from the top of the column and through the display base
plate. When the connector of the new cable clears the top of the column, disconnect and
discard the original ribbon cable.
25. Support the display housing while you connect the new upper ribbon cable to the upper
PCA.
26. Line up the tabs on the display housing with the tab holes on the display base
plate.