Service manual

C762, C764, C764i Stairclimber
Page 62
Procedure 7.13 - Replacing a Magnet Assembly
Each magnet assembly consists of an upper and a lower magnet coil. Diagram 7.8 shows the
magnet assemblies used on the C760 Series Climbers.
Removing a Magnet Assembly
1. Remove the covers as described in Procedure 7.1.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the blue, red, and yellow wires from the magnet coils on the magnet assembly you
are removing.
3. Remove the fasteners that secure the magnet assembly to the frame upright. Set aside the
magnet assembly.
4. If you are removing only one magnet assembly...
THEN... OTHERWISE...
Continue with the next step. Repeat Steps 2 and 3 for the second
magnet assembly; then continue with
the next step.
Diagram 7.8 - Magnet Assemblies
Magnet
Coil
Magnet
Assembly