Service manual

C762, C764, C764i Stairclimber
Page 65
Procedure 7.14 - Replacing a Return Spring
Removing the Return Spring
If you are removing only one return spring, remove only one cover. It is not necessary to remove
both covers unless you are removing both return springs.
1. Remove the cover necessary to access the return spring you are removing as described in
Procedure 7.1.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Press down the stair arm with one hand. With your other hand, grasp and pull the end of the
stairarm belt connected to the return spring. Release the stair arm. Remove the belt from
the pulley and belt idler (see Diagram 7.10).
3. Remove the return spring from the grooved belt clamp and spring bracket.
4. If you are replacing only one return spring...
THEN... OTHERWISE...
Continue with the next step. Repeat Steps 2 and 3 for the second
spring; then continue with the next
step.
Diagram 7.10 - Removing a Stairarm belt