Service manual

C762, C764, C764i Stairclimber
Page 67
8. Lift the stair arm assembly from the frame weldment. Grasp the Stairarm belt and lift it over
the toothed pulley. Route the belt under the idler pulley.
9. If you are replacing only one return spring...
THEN... OTHERWISE...
Continue with the next step. Repeat Steps 5 through 8 for the
second spring; then continue with the
next step.
10. Check the operation of the climber as described in Section Four, then replace the cover as
described in Procedure 7.1.