Service manual

C762, C764, C764i Stairclimber
Page 68
Procedure 7.15 - Replacing A Stairarm Belt
Removing the Stairarm Belt
If you are removing only one stairarm belt, remove only one cover. It is not necessary to remove
both covers unless you are removing both stairarm belts.
1. Remove the cover necessary to access the stairarm belt you are removing as described in
Procedure 7.1.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Press down the stair arm with one hand. With your other hand, grasp and pull the end of the
stairarm belt connected to the return spring. Release the stair arm. Remove the belt from
the pulley and belt idler (refer back to Diagram 7.10).
3. Remove the spring from the grooved belt clamp.
4. Remove the fasteners that hold the halves of the grooved belt clamp together (see Diagram
7.12).
5. Remove the fasteners that secure the belt clamp to the underside of the pedal. Set aside the
belt clamp and stairarm belt.
6. If you are replacing one stairarm belt only...
THEN... OTHERWISE...
Continue with the next step. Repeat Steps 2 through 5 for the
second stairarm belt; then continue with
the next step.
Diagram 7.12 - Stairarm Belt Clamps