Service manual

C762, C764, C764i Stairclimber
Page 70
Diagram 7.14 - Underside of Stairarm Pedal
Note:
Hold the sides of the grooved belt clamp together when you perform the next step.
13. Install the fasteners that hold the sides of the grooved belt clamp together.
14. Place the return spring in the grooved belt clamp. Position the spring as shown in Diagram
7-14.
15. Lift the stair arm assembly from the frame weldment. Grasp the stairarm belt and lift it over
the toothed pulley. Route the belt under the idler pulley
16. If you are replacing only one stairarm belt...
THEN... OTHERWISE...
Continue with the next step. Repeat Steps 7 through 15 for the
second stairarm belt; then continue with
the next step.
17. Check the operation of the climber as described in Section Four, then replace the cover as
described in Procedure 7.1.