Service manual

C762, C764, C764i Stairclimber
Page 88
21. Push the disk assembly through the drive belt. Position the belt against the disk hub and
behind the drive belt idler as you slide the disk assembly into the disk brackets.
Important
Make sure that the remote sensor assembly tabs straddle the disk target.
22. Using the 17mm open-end wrench, tighten the outer nuts on each end of the disk axle.
23. Return to Step 14.
24. Remove the set screws that secure the sheave to the sheave shaft. Gently tap the sheave
to re-position it on the sheave shaft.
25. Add a drop of blue loctite to the tip of each set screw. Install the screws on the sheave hub.
26. Return to Step 16.
27. Inspect the gaps between the disk and the magnet assemblies as described in Procedure
5.1.
28. Check the operation of the climber as described in Section Four, then replace the covers as
described in Procedure 7.1.