Service manual

C762, C764, C764i Stairclimber
Page 90
Diagram 7.19 - Idler Arm Assembly
Removing the Drive Belt Idler
10. Using the needle nose pliers, remove the hitch pin from the clevis pin that secures the idler
arm to the climber frame. Hold the idler arm while you remove the clevis pin from the climber
frame.
Note:
Set the idler arm assembly on a work bench while you perform the following steps.
11. Remove the retaining ring from the drive belt idler.
12. Slide the drive belt idler and wave washer from the idler shaft weldment.
Replacing the Drive Belt Idler
13. Visually inspect the wave washer removed in Step 12 for wear or damage. If the visual
inspection indicates no wear or damage...
THEN... OTHERWISE...
Use the original washer when you Use a new washer when you perform
perform the next step. the next step.
Spring
Idler Arm