Service manual

C762, C764, C764i Stairclimber
Page 94
Note:
Hold the belt clamp against the belt and slotted area on the underside of the pedal when you
perform the next step.
12. Install the fasteners that secure the belt clamp to the pedal.
13. Lift the stair arm assembly from the frame weldment. Grasp the toothed belt and lift it over
the toothed pulley. Route the belt under the idler pulley.
14. If you are replacing one stair arm assembly only...
THEN... OTHERWISE...
Continue with the next step. Repeat Steps 7 through 13 for the
second stair arm assembly; then
continue with the next step.
15. Check the operation of the climber as described in Section Four, then replace the covers as
described in Procedure 7.1
Diagram 7.20 - Stairarm Assembly