Service manual

C762, C764, C764i Stairclimber
Page 95
Procedure 7.23 - Replacing a Handlebar Assembly
Removing the Handlebar Assembly
1. Turn off the climber with the circuit breaker, then unplug the power cord from the wall outlet.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Slide the handlebar boot up on the handlebar.
3. Remove the fasteners that secure the lower end of the handlebar assembly to the handlebar
post (see Diagram 7.21). Set aside the button head screw and locknut.
Note:
Do not remove the handlebar assembly from the post at this time.
4. Loosen the fasteners that secure the handlebar assemblies to the upper handlebar clamp.
Slide the handlebars out of the handlebar clamp.
5. Remove the handlebar assembly from the handlebar post by lifting the assembly up and to
the side of the handlebar post. Remove the handlebar boot from the handlebar. Set aside
the handlebar and boot.
Diagram 7.21 - Lower Handlebar Assembly
Handlebar Boot
Lower Handlebar