Service manual

C762, C764, C764i Stairclimber
Page 99
Diagram 7.24 - Display Base Plate
11. Position the display base plate on top of the column. Line up the tabs on the back of the
display base plate with the holes in the sides of the column.
12. Install the fasteners that secure the display base plate to the column.S
13. Slide the enclosure collar down the column and over the column mounting screws. Press
down to ensure a snug fit.
14. Position the upper handlebar clamp next to the column. Position the upper handlebar clamp
so that it is parallel to the display base plate (see Diagram 7.24).
15. Install the fasteners that secure the upper handlebar clamp to the column.
16. Replace the handlebar assemblies as described in Procedure 7.23.
17. Check the operation of the climber as described in Section Four, Checking Unit Operation.
Display Base Plate
Handlebar Clamp