Owner`s manual

page 20
COMMERCIAL PRODUCTS DIVISION
To access the Club settings, the following must occur:
❑ Electrical power must be supplied.
The foot pedal speed must be maintained at 40 strides per minute. Or, the
optional battery recharger must be plugged into the EFX and connected to an
appropriate power source.
❑ Check that the Precor banner appears on the display and maintain the
minimum stride rate.
❑ Press the appropriate key sequences.
Important: To access Custom Club Mode, press Reset while the Precor banner is
displayed. Within 1/2 second, begin pressing the key sequences. If the system does
not detect a key press (within 1/2 second after Reset), it returns to the banner. Once
you begin entering a key sequence, each key must be pressed within four seconds of
the other or the Precor banner reappears and you have to begin again.
To change the language, select the units of measure, and set the maximum work-
out and pause times, press the following:
Reset, Resistance ▼, ▲, ▼, Reset, Resistance ▼, ▲, ▼
Note: The ▼ and ▲ symbols shown above represent the Resistance keys. Do not
use the Cross Ramp ▼▲ keys to attempt access to the Club Custom Mode.
The functions of the display console keys while in Club Custom Mode are described
in the box below.
Display key functions within the Club Custom Mode
Reset exits Club Custom Mode and
displays the Precor banner.
Note: The touch-sensitive keys can be gently pressed and held to view several
selections. The longer the key is held down, the faster the numbers scroll past.
SELECTING THE LANGUAGE
Display prompts can appear in English, German, Spanish, French, Dutch, or
Portuguese. Use the ▼▲ keys to make your choice and press Enter to select it.
DETERMINING THE UNITS OF MEASURE
Two different units of measure can be selected, Metric or U.S. Standard . Make your
selection using the ▼▲ keys. Press Enter once the correct unit is displayed.
Note: Anytime you wish to exit the Club Custom Mode, press the Reset key. Any
previous display attributes that you selected by pressing Enter are saved and
recorded in memory.
▼▲ lets you scroll through the
various selections that appear.
Enter saves the information being
displayed and moves to the
next aspect of the program.