User Manual

FUTABA TRANSMITTER AND RECEIVER SETUP
Transmiter Setup
Follow the chart below for setup of your Futaba transmitter. Be sure to start with a blank and freshly reset model memory
before starting setup.
14
TRANSMITTER CONFIGURATION GUIDE
End Points
(Travel Adjust
or ATV)
Thro/Ail/Ele/Rud
CH5/CH6
120%
100%
Sub Trim
Use the Betaflight or SpeedyBee application and adjust to achieve "1500" center
on the receiver tab of the app. Covered on P19 of this instruction manual.
Trim Levers
Verify at zero
CH. 5 (Gear)
Assigned to a 2-position switch (selects FLEXF3 Control Profiles)
Reversing
Thro - Set Per Page 19
Timer
Wing/Tail Type
1 Aileron, 1 Elevator, 1 Rudder
CH. 6 (Aux 1)
Futaba
Start with: 2:20 (3S 2200mAh), 3:00 (3S 2600mAh), 3:40 (3S 3500mAh)
Rudder - NormalAileron - Normal Elevator - Reversed
Assigned to a 3-position switch (selects FLEXF3 Flight Configurations)
Channel Assignment
Your transmitter's instruction manual is the best place to find information on how to assign channels in your transmitter.
(CH6 set to 100% initially, fine tuned later in this manual)