User Manual

MAIN WING INSTALLATION
Required Tools and Fasteners:
#1 Phillips Screwdriver
(2) M3x25 Self-Tapping Screws
1.
2.
3.
4.
5.
6.
Invert the airplane so that the belly is facing up. Remove the belly hatch by pulling the exposed tab away from the fuselage.
Install the wing tube into the fuselage.
Slide the left or right wing panel on the wing tube and guide the servo wire and LED wire (night version only) into the fuselage.
Secure the wing to the fuselage with one (1) M3x15 self-tapping screw. Push the wing tube completely into the wing until it stops. Do
not force it into place.
Slide the other wing panel on the wing tube and guide the servo wire into the fuselage. Seat the wing to the fuselage completely, but do
not force it into place.
Plug the left aileron servo wire into the S2 port of the Aura, and the right aileron servo wire into the S3 port of Aura. Connect the LED
wires directly to the LED controller.
14
Occasionally there may be some flashing left inside the wing tube support rings inside the wing panels. This flashing may prevent the
wing tube from seating fully into the wing. You can remove this flashing with a hobby knife or a dowel wrapped with some 300 grit
sand paper. Do NOT shorten the wing tube, as it relies on this outer ring for structural support.
NOTICE
Servo Arms
Aileron
Control Horns
Aileron