Installation Instructions

1) Turn the sink face down on top of the countertop making sure to leave at lease 4 for the faucet.
Using a pencil, trace around the sink where the sink touches the countertop. Remove the sink
and draw a new line 3/4 inside the previous line. Erase the outer line.
2) Measure the outline against the sink to make sure you have everything correct before cutting.
The measurements should allow the sink to drop into the cutout and the skirt rest on the counter.
After verifying measurements, cut the hole out of the countertop.
3) Using the copper sink installation siilicone put a bead of silicone into the recessed area of 3) Using the copper sink installation siilicone put a bead of silicone into the recessed area of
sink drain opening. Install the drain into the sink. It is much easier to do this at this stage than
after the sink is installed.
4) Place the sink into the cutout hole. Align the sink in the counter and trace the outer rim so
that it stays in the correct position. Have a second person hold the sink in place while you run
a bead of Copper Sink Installation Silicone around the outer rim. Drag your finger around the
outer rim to smooth out the silicone.
5) Wipe any excess silicone off the countertop using a clean dry rag. 5) Wipe any excess silicone off the countertop using a clean dry rag.
Allow to dry for 24 HOURS before using your sink.

Summary of content (1 pages)