Specifications

CMF
Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 5
Installing the Mount Sliding Plate to a Wood Stud
➊
Remove the mount sliding plate from the cable
mounting plate (Figure 1).
➋
Use a stud nder and pencil to mark the center of a
wall stud.
➌
Place the mount sliding plate on wall and align its
screw holes with the center mark.
The visual centering diamond on the mount
sliding plate will help you determine where the
center of the at-panel will be on the wall
(Figure 1).
➍
Use a pencil to mark the two (2) screw hole locations
along the stud (Figure 2).
➎
Remove the mount sliding plate.
➏
Drill two (2) holes in the center of each screw hole
location using a power drill and a ⅛" drill bit
(Figure 3).
Only use a ⅛" drill bit when drilling holes.
➐
Place the mount sliding plate against the wall and
align it with the holes.
➑
Insert one (1) #10 x 1¾” wood screw into each
mounting hole of the mount sliding plate (Figure 4).
Do not overtighten the wood screws.
Go to the “Attaching the Bolt Spindles to the Flat-
Panel” section on page 6.
Figure 2
Figure 3
Figure 1
Cable Mounting
Plate
Visual Centering
Diamond
Mount Sliding
Plate
Figure 4