ECM-D70T / ECM-D70T1.
ECM-D70T / ECM-D70T1.5 Contents Installation Tools........................................................................................................................................................ 3 Parts List................................................................................................................................................................... 3 Mounting Hardware.................................................................................................................
ECM-D70T / ECM-D70T1.5 Installation Tools The following tools may be required depending upon your particular installation. Tape Measure Protective Eye Wear Phillips Tip Screwdriver Pencil Ladder Parts List Make sure that none of these parts are missing and/or damaged before beginning installation. If there are, stop the installation and call Premier Mounts at (800) 368-9700.
ECM-D70T / ECM-D70T1.
ECM-D70T / ECM-D70T1.5 Features The ECM-D70T / ECM-D70T1.5 ceiling mount fits dual flat-panels up to 50” in either portrait or landscape orientation. It offer dynamic viewing with 360° swivel and 15° of tilt. The mount’s ultra-thin design keep s the center of gravity close to the flat-panels for better balance. Integrated cable management keeps the installation clean and organized. Optional brackets are available for attaching mini PCs and digital media players and servers (see page 11).
Attaching the ECM-D70T to the Ceiling ECM-D70T / ECM-D70T1.5 Step 1 A 1-½ ״or 2” NPT threaded pipe must be firmly secured to the ceiling structure before performing the following steps. The Phillips set screw must be backed out in order for the NPT threaded pipe to attach to the threaded coupler. ➊➊ ➋➋ Align the ECM-D70T threaded coupler with the threaded end of the NPT threaded pipe.
ECM-D70T / ECM-D70T1.5 Selecting the Appropriate Mounting Hardware ➊➊ Insert a small straw or toothpick into the threaded ➋➋ ➌➌ ➍➍ ➎➎ inserts found on the bottom or top of the projector. Use a pencil to mark the depth of the threaded insert on the small straw or toothpick. Mark the straw or toothpick 1/8” above the depth of the threaded insert, as shown in Figure 1.
ECM-D70T / ECM-D70T1.5 Griplate™ Washer Installation Premier Mounts’ Griplate™ Washers are designed to accommodate the various M4, M5, M6 and M8 hole sizes required by flat-panels. For Griplate™ installation, the dimples must be facing the flat-panel for the lower mounting points. For the upper mounting points, the dimples must be facing away from the flat-panel. M8 M6 M5 M4 Do not place excessive pressure on the back of the flat-panel, as this may damage your flat-panel.
ECM-D70T / ECM-D70T1.5 Flat-Panel Installation Step 1 Install the mount according to the instructions provided by Premier Mounts. Perform all structural reinforcements before attaching the flat-panel to the ceiling mount. Do not release the flat-panel until the mounting bracket arms are fully resting on the elliptical mounting bar. Raise the mounting bracket arms and the attached flatpanel over the elliptical mounting bar of the ECM-D70T. The cable access ports face the rear of the flatpanel.
Attaching Decorative Covers ECM-D70T / ECM-D70T1.5 first Step 1 When attaching the decorative covers, verify the direction of the covers. The smaller mounting hole should be in position above the larger mounting hole. ➊➊ ➋➋ Place the first decorative cover over the first mounting bracket arm and push firmly into place. Repeat Step 1 for the second decorative cover and mounting bracket arm. Mounting Bracket Arm Decorative Cover Step 2 ➊➊ ➋➋ Align the mounting holes.
ECM-D70T / ECM-D70T1.5 Tilt Positioning Adjusting the Flat Panel Friction Tilt Angle ➊➊ ➋➋ ➌➌ Adjusting the Flat Panel to the Original Position Place one hand at the center top edge of the flat-panel. Place the other hand on the center bottom edge of the flat-panel. Using the upper hand, gently pull the top of the flat-panel towards you while the lower hand gently pushes the bottom of the flat-panel away from you. ➊➊ ➋➋ ➌➌ Place one hand at the center top edge of the flat panel.
ECM-D70T / ECM-D70T1.5 Technical Specifications All measurements are in inches(mm). 80.17 3.156 1778 70.000 85.15 3.352 845.96 33.306 195.47 7.696 548.77 21.605 38.10 1.500 63.50 2.500 Page 12 Visit the Premier Mounts website at http://www.premiermounts.
ECM-D70T / ECM-D70T1.5 Warranty PREMIER MOUNTS LIMITED LIFETIME WARRANTY What and Who is Covered by this Limited Warranty and for How Long Premier Mounts warrants this product to be free from defects in material and workmanship for the lifetime of the original owner of this product. The limited warranty is valid only for the original purchaser of the product.
