Specifications

Page 6 Installation Instructions
FLIP Mount
Step 3. Line the FLIP Mount up with the two
pre-drilled mounting holes and use
two (2) #14 x 7/8” wood screws and
secure the FLIP Mount to the underside
of the cabinet using a screwdriver.
#14 x 7/8” Wood
Screw
Screwdriver
FLIP Mount
Do NOT over-tighten the wood
screws, as this could cause the
threads to strip out the wood
inside the cabinet enclosure.
Softwood Cabinet Installation
1/4-20 Tee Nut and screws are recommended when installing the FLIP mount into softwood surfaces.
Step 1. Use a 5/16” drill bit and drill to pre-drill the tee nut pilot holes in the underside of the cupboard.
Step 2. After drilling the mounting holes, open the cupboard door and place two (2) 1/4 - 20 tee nuts into each hole (see inset above).
Use a hammer to gently tap into place.
Step 3. Line the FLIP Mount up with the two pre-drilled mounting holes.
Step 4. Using a screwdriver, insert and tighten two (2) 1/4 - 20 x 5/8” screws and attach the FLIP Mount to the underside of the
cabinet.
1/4-20 x 5/8”
Screw
Screwdriver
FLIP Mount
1/4-20 Tee
Nut
1/4-20 Tee
Nut
Cupboard
Pre-drilled
Hole
(5/16” drill
bit)