Specifications

Installation Instructions Page 7

FLIP Mount

Step 5. Using a portable drill, insert and tighten two (2)

#14 x 2” wood screws.

Do NOT over-tighten the wood screws, as this

could cause the threads to strip out the wood

inside the wall stud.

1/8” Drill

Bit

Step 4. Using a 1/8” drill bit, pre-drill both pilot

holes at the marked locations.

Before drilling the pilot holes, line

up the mounting holes with the

pencil marks and level the FLIP

mount, if needed.

Wall Stud

#14 x 2” Wood Screw

Screw driver

FLIP Mount

Mount Installation - Wall Surface (Optional)

Wall Stud

Electronic

Stud Finder

Step 1. If the location where the ﬂ at panel will be

installed is acceptable, use a stud ﬁ nder to

determine the exact center of each stud.

Step 2, Once a wood stud has been located, mark

this spot with a pencil. This will be the upper

mounting point.

Step 3. Mark the lower mounting point as well, once

the upper mounting point has been marked.

Mark

Wall Stud

FLIP Mount