Specifications

Page 8 Installation Instructions

FLIP Mount

Attaching the Flat Panel

Step 1. Locate the mounting points that are on the back of the ﬂ at panel.

Step 2. Line up the mounting points on the ﬂ at panel with the corresponding mounting holes on the FLIP mount.

Step 3. Loosely attach the upper two (2) M4 x 10 mounting screws.

Step 4. Insert the screw heads into the corresponding keyhole mounting slots that are on the FLIP mount.

Step 5. With the FLIP mount securely attached, insert and tighten the two (2) lower M4 x 10 mounting screws.

Step 6. Use a screwdriver to tighten all mounting hardware at this time.

M4 x 10mm

Screw

Flat Panel

FLIP Mount

Keyhole Mounting

Slot

M4 x 10mm

Screw

Mounting Point

M5 x10mm Flat Head Screw (see NOTE:)

If you chose not to use the 360° feature of the FLIP mount, please insert and tighten one (1) M5 x 10mm ﬂ at head screw

into any one of the four mounting point locations (please see below for mounting points). The M5 x 10mm ﬂ at head screw

will prevent the FLIP mount from rotating 360°.

If you chose not to use the 360° feature of the FLIP mount, please insert and tighten one (1) M5 x 10mm ﬂ at head screw

into any one of the four mounting point locations (please see above for mounting points). The M5 x 10mm ﬂ at head screw

will prevent the FLIP mount from rotating 360°.