INSTALLATION MANUAL MULTI-MONITOR MOUNT FLAT PANEL DISPLAY MOUNT Model # MMT Model # MMW 3130 E. Miraloma Ave. Anaheim, CA 92806 Phone: 800 368-9700 Fax: 800 832-4888 www.mounts.
Contents - Assembly drawing - Parts list - Mounting the table top stand - mounting LCD monitor to multi-mount assembly - Threading cables through post - Mounting Multi-Monitor assembly to the wall - Making adjustments to the Multi-Monitor assembly The wall structure or table top must be capable of supporting at least five (5) times the weight of the flat panel(s). If not, the wall or table top must be reinforced.
Assembly drawings Dimensions are in Inches and (mm) 45.00 (1143) Ø2.00 (50.8) A 24.00 (609.6) B D 4.87 (123.7) A B B B 7.50 (190.5) A B C .13 (3.3) C 3.20 (81.28) 1.60 (40.64) Model: MMT Description A. Adjustable Multi-Monitor assembly B. Flat Panel Mounting brackets VESA 75/100 C. Removable desk clamp D. Adjustable safety knob E. Wall mount 45.00 (1143) F A Ø2.00 (50.8) B A 13.53 (343.66) E 4.87 (123.7) 18.53 (473.2) B 4.71 (119.
Parts list NOTE: This wall mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing before beginning installation. If there are parts missing stop the installation and contact Premier Mounts.
Mounting the Multi-Monitor Mount to a desk or hard surface (model: MMT) WARNING : Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the flat panel(s). Monitor To secure the Multi-Monitor mount to a desk or hard surface position the post & clamp on the edge of the desk or hard surface. Then secure the Post by turning the two desk clamps until finger tight.
Threading cables through cable access holes (model: MMT) To thread the cable or cables from the monitor through the post, start at the top access hole and gently pull cable out of the bottom access hole.
Mounting Multi-Monitor assembly to wall mount (model: MMW) Align the Multi-Monitor Assembly with the wall mount and slide the arm down around the wall mount post. To secure the arm to the wall mount, finger tighten the safety knob until the arm is secure.
Adjustments Multi-Monitor assembly (3)Mounting brackets Mounting brackets on arms only slide inward and outward to different positions. See figure 6 Desk clamp Multi-Monitor assembly Adjustable safety knob (3)Mounting brackets The arms of the Multi-Monitor assembly can be pulled in or out for desired positions.