INSTALLATION INSTRUCTIONS PP-FCTA Suspended Ceiling Adapter EUROPE NORTH AMERICA 3130 East Miraloma Avenue Anaheim, CA 92806 USA USA and Canada Phone: 1.800.368.9700 Fax: 1.800.832.4888 Other Locations Phone: (001).714.632.7100 Fax: (001).714.632.
PP-FCTA Contents Weight Limit...................................................................................................................................................................... 2 Warning Statements......................................................................................................................................................... 2 Installation Tools.........................................................................................................................
PP-FCTA Installation Tools The following tools may be required depending upon your particular installation. They are not included. Ladder Hand Held Drill 1/8˝ Drill Bit Pencil 1/4” Concrete Drill Bit Phillips Tip Screwdriver Protective Eyewear Hammer Hole Saw Parts List Make sure your Premier Mounts product has the following hardware and components before beginning installation. If there are parts missing and/or damaged, stop the installation and call Premier Mounts at (800) 368-9700.
PP-FCTA Features The suspended ceiling adapter makes it easy to install and fine-tune the position of your overhead projector and organize its electrical wiring above the ceiling. Mounting Coupler Use a set screw to hold any 1 ½” NPT pipe to the mounting coupler Adjustability Up to 9˝ of lateral shift Electrical Access Knockouts for electrical or signal junction boxes Camera Screw Hole Use a 1/4”-20 screw to mount a camera alongside the projector Page 4 Visit the Premier Mounts website at http://www.
PP-FCTA PP-FCTA Installation Introduction Read these instructions before installing your Premier Mounts product. Make sure you have all the parts and tools you need to safely complete the installation. Some of the steps in this installation may require two people to prevent personal injury and/or damage to the projector. Read all the warnings in the manual and always use proper safety equipment.
PP-FCTA Securing the Ceiling Plate 1) Once the ceiling plate assembly is resting on the t-bar frame rails, use a screwdriver to tighten the four (4) M5 x 16mm combo screws. 2) Slide and center the upper plate assembly over the hole that was cut in the tile. 3) Tighten all four (4) wing nuts. Do not overtighten the mounting screws. Upper Plate Assembly Upper Adapter Plate Proceed to the ″Electrical Box Cut-out Removal″ section below.
PP-FCTA Ceiling Attachment Hook the four (4) turnbuckles into the four corners of the main ceiling plate. Then choose one of the three ceiling attachment Wood Stud Ceiling 1) Determine a suitable structure capable of supporting the intended weight to drill the mounting holes. 2) 3) 4) 5) 6) 7) 8) Set the holes so that wires from the main ceiling plate will angle 15 degrees outward (see Fig. 1). Use a 1/8˝ drill bit to drill the mounting holes.
PP-FCTA Ceiling Attachment (cont’d) Truss Ceiling Ceiling Truss 1) Loop the wire around the truss (see Figure 1). Hang the wires from the trusses so that they will angle 15 degrees outward from the main ceiling plate (see Fig. 2). 2) Twist the wire at least five (5) times around itself to secure it. 3) Run the other end of the wire through the turnbuckle. 4) Twist the wire at least five (5) times around itself to secure it. 5) Repeat steps 1-4 for the remaining three mounting points.
PP-FCTA-QL Camera Screw Installation (optional) Make sure the camera supports one (1) 1/4”-20 screw. 1) Determine which screw hole on the upper adapter plate you will use to attach the camera. 2) Insert one (1) 1/4”-20 x 2 3/4” pan Phillips head screw (commercially available) through one (1) wing nut (commercially available) and the desired screw hole. The screw should go through both the upper and lower adapter plates. It will later be used to mount the camera. Do not overtighten the mounting screw.
PP-FCTA Technical Specifications All measurements are in inches. 23.25 590.5 23.70 602 1.18 30.1 24.45 621 SLIDING PLATE 4.50 114.3 3.50 88.90 PIPE THREADS 1.5" NTP .81 1.18 24.75 8.43 1.00 3.25 6.50 Page 10 .75 Visit the Premier Mounts website at http://www.mounts.
PP-FCTA Warranty PREMIER MOUNTS LIMITED LIFETIME WARRANTY What and Who is Covered by this Limited Warranty and for How Long Premier Mounts warrants this product to be free from defects in material and workmanship for the lifetime of the original owner of this product. The limited warranty is valid only for the original purchaser of the product. What Premier Mounts Will Do At the sole option of Premier Mounts, Premier Mounts will repair or replace any product or product part that is defective.