Installation instructions

PBM-250L

Projector Mount

INSTALLATION INSTRUCTIONS

 Step 1

Invert the projector and place it on a soft and flat surface.

Locate the five (5) 8 (mm) mounting points found on the bottom of

the projector. Align the mounting bracket (B) to the projector (C)

and secure the bracket with the five (5) 8 (mm) x 35 (mm) Phillip

Screws (A) Lock Washers (D) Flat Washers (E) (supplied).

Do not over tighten!

See Figure 1

 Step 2

Install the base box securely to the ceiling structure in accordance

with proper commercial standards. Use (commercially available)

suitable hardware depending on the installation requirements.

NOTE

If the (Optional) AST-2446 adjustable height suspension

adapter is a part of the installation, securely install the ceiling

adapter to the ceiling at this time.

(Refer to its Installation Instructions)

 Step 3

Install the two (2) conical spacers (L) and two (2) flat washers (K), two

(2) hinge pin screws (J) loosely on both sides of the base box (H).

Raise the projector with the mounting bracket attached and slip though

the hinge pin slots openings on the bracket into the base box. Install the

two (2) angle locking screws (I). Adjust the angle, lock it, and then

tighten the hinge pin screws.

See Figure 2

 Step 4

Check all the hardware for proper tightness and security. Do not

over tighten hardware.

PAGE 1
PBM-250L NOTE: If the (Optional) AST-2446 adjustable height suspension Projector Mount INSTALLATION INSTRUCTIONS Step 1 Invert the projector and place it on a soft and flat surface. Locate the five (5) 8 (mm) mounting points found on the bottom of the projector. Align the mounting bracket (B) to the projector (C) and secure the bracket with the five (5) 8 (mm) x 35 (mm) Phillip Screws (A) Lock Washers (D) Flat Washers (E) (supplied).
PAGE 2
Step 5 Install the two (2) conical spacers (L) and two (2) flat washers (K), two (2) hinge pin screws (J) loosely on both sides of the base box (H). Raise the projector with the mounting bracket attached and slip though the hinge pin slots openings on the bracket into the base box. Install the two (2) angle locking screws (I). Adjust the angle, lock it, and then tighten the hinge pin screws.