Installation manual

PSD-TS
Page 6 Installation Manual
Attaching the Display
This stand is intended for use only with the maximum
weights indicated. Use with products heavier than the
maximum weights indicated may result in instability
causing possible injury.
The flat panel display is very heavy; two people are
required to lift the flat panel and secure it to the
stand.
To install the PSM-series or CTM-series mounting
brackets to the flat panel, refer to its installation
instructions.
The diagrams (to the right) show the CTM and PCM series
systems.
PSM-Series: Raise the flat panel display with the mounting
bracket secured and insert the four (4) tab
openings from the PSM mount to the four (4)
receiving tabs found on the back plate
Push the flat panel display down, right and
down again to lock the mount together.
Make sure all tab openings are interlocked with
the receiving tabs before letting go of the flat
panel.
Secure the brackets with two (2) M6 x 12mm
Phillips (supplied) screws for additional security.
Raise the flat panel display with the left and right
brackets secured to the plasma and insert the
bottom and top hooks from the mounting arms to
the top and bottom rods found on the CTM back
plate. Secure the mounting arms with the two (2)
M6 x 12mm Safety knobs (supplied).
The safety knobs MUST be used. Failure to do so
may result in damage to the flat panel display or
personal injury.
CTM
Series
PSM
Series
PSM Back
Plat
e
PSM
Mounting
Bracket
Flat Panel
PSD-TS
Base
CTM Back
Plat
e
M6 x 12mm
Safety Knobs
CTM Series
Mounting
Brackets
Flat Panel
PSD-TS
Base
M6 x 12mm
Security
Screws
1
2
3