Installation manual

PSD-TS
Installation Manual Page - 7 -
Optional Items
Floor Installation
1. If securing the base to the floor, use (commercially
available) hardware.
Shelf Installation
Do not install the optional shelf higher than 39”.
If using a shelf, please install prior to attaching the
display.
1. The shelf must be attached before the flat panel display and
PSD-SPA adapter is installed to the stand.
2. Install the shelf to the poles by sliding the shelf over the
poles and down into position.
3. Determine the final height and secure the shelf using four (4)
M8 x 10mm set screws.
4. Tighten these screws using the supplied Allen wrench.
Suitable
Hardware
(Commercially
Available
)
PSD-TS
Optional
Shelf
PSD-TS
M8 x 10mm
Set Screw