INSTALLATION MANUAL PLASMA DISPLAY MOUNT MODEL For service and parts contact: Premier Mounts 3130 E. Miraloma Ave Anaheim, CA USA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 Visit us at: www.mounts.
Contents -2- o Safety & precautions o Mount diagrams o Parts List o Optional Adapters o Installing the mounting bracket o Installing the mount o Electrical o Securing the mount o Additional security
Safety & Precautions WARNING: Safety precaution measures must be practiced at all times during the installation of this product. Use proper safety gear and tools for the installations procedure to prevent personal injury or damage to the plasma displays or plasma mounts. The wall or ceiling structure must be capable of supporting at least five (5) times the weight of plasma display. If not, the wall or ceiling must be reinforced.
Mount Diagrams 19.771 TILT BACK PLATE PART#: PSB-TBP MATERIAL: 12 (GA) CRS COLOR: Black powder coat 1.250 1.000 1.750 1.125 e 16.000 F 5.460 2.865 A 3.500 d 8.000 A. Lag bolt access slot. B. Mounting points (4.5") used on installations other than wall mounting. C. Access hole for power or cables. D. Mounting points for additional security screws. 5.000 18.500 4.500 8.000 b 3.250 4.500 5.460 16.
Parts List HARDWARE LIST QTY SIZE DESCRIPTION 6 1 1 2 5/16” Dia M6 x 12 (mm) Phillip security screws 1 6 M8 x 20 Phillip screws Lag bolts Mounting bracket PSB-TBP tilt back plate Used for additional security on tilt mounts, mobile carts, floor stands and ceiling mounts Installations instructions Mount hardware TOOLS NEEDED o o o o o o o o o Phillips screwdriver Drill gun Soft material or a blanket Pencil ¼" drill bit Level Measuring tape Wrench with a 1/2" socket Stud finder CEILING ADAPTER
Installing the mounting bracket WARNING : Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the plasma display. Step 1 CAUTION: The plasma displays are fragile and heavy. At least two (2) qualified personnel are strongly recommended for the installation of this product.
Installing the mounts Step 3 Select the area where the plasma will be installed and make sure it can support the weight standards (see warning on page 3). Locate the 16" wood stud centers behind the wall using a (commercially available) stud finder and mark the center of the studs when found. Set the mounting bracket to the wall and mark the desired height by marking the center of the tilt back plate.
To determine the desired viewing height, use the center slot opening in the wall mount as a center reference for the plasma television when mounted. Once the height is determined, use the bubble level to insure that the bracket is level. Next, using a pencil, mark the six (6) lag bolt slot openings on the mounting bracket. Before continuing, confirm the marks are located on the center of the studs. Drill 1/4" pilot holes on the six (6) markings on the wall.
Securing the mount Step 5 Warning: The plasma display is heavy and 2 people are needed to lift and install it. Failure to do so could result in serious personal injury. Before placing the plasma on the wall recheck all hardware for proper tightness and security. Before installing, become familiar with the way the plasma mount attaches to the wall mount. Align the four (4) tab openings to the four (4) receiving tabs on the tilt back plate.