Installation Guide

Shut off water supply at angle stop. Remove
old faucet. Clean sink surface in preparation
for new faucet.
Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
3.
2.
4.
1.
INSTALLATION STEPS: Two handle lavatory faucet
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
INSTALLATION
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8 in. O.D. ball-nose riser (1,
not included). Before tightening the faucet
connector to the water supply, apply a second
wrench to the supply tube fitting. This will
prevent the supply tube from moving or
twisting when tightening the faucet connector.
Do not overtighten.
5.
9.
Attach horizontal rod (1) to strap (2) using
clip (3). Insert lift rod (4) into strap and
tighten screw (5). Connect assembly to drain
(6).
10.
2
1
6
5
3
Model Number: 120341LF & 120342LF & 110704
Slide hot and cold end valves through sink
mounting holes. Make sure long tubes are
installed away from spout. Note: Hot side
end valve is labeled. Secure end valves
with washers and nuts. Hand tighten nuts
onto shank. Lock nuts into position by
tightening screws.
Place spout assembly through mounting hole
in sink. Secure spout with rubber washer,
metal washer and nut.
Align tabs (1) and tabs (2) on quick
connects (3). Push quick connects firmly
upward and snap onto receiving tube tab
(1). Pull down moderately to ensure each
connection has been made.
3
1
2
Hole for lift rod
Sink
Washers
4
3
2
1
Brand Lavatory Faucets
7
8
3
11
10
4
5
6
9
2
1
Remove the stopper (1) and the flange (2). Screw
the brass nut (3) all the way down. Push the plastic
washer (4) and the gasket (5) down. Unscrew the
pivot nut (6) from the pop-up body (7) and remove
the seal washers (8). Take off the spring clip (9)
from the horizontal rod (10). Remove the tailpiece
(11) from the pop-up body (7).
6.
4
Apply the silicone to the underside of the flange (2).
Insert the pop-up body (1) into the drain hole from
below sink. Screw the flange (2) into the pop-up body
(1). With the pivot hole (3) facing toward faucet, Use
groove joint pliers to tighten the nut (4), do not over
tighten. Do not turn the pop-up while tightening the
nut, or sealant may not seal drain. Clean excess
putty.
Apply thread sealant tape to the top threads of
the tailpiece (5) in a clockwise direction, as shown
and hand tighten.
5
4
3
1
2
7.
3
2
1
8.
Install the horizontal rod (2) and the stopper (3) as
shown (4). Hand tighten the pivot nut (1).
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty