Installation Guide

Install faucet into sink by leading all hoses
down center through center hole. From
under sink, threaded mounting nut .
Insert spray hose down through support and
sink. Attach spray hose to spray hose nipple.
Shut off water supply at angle stop . Remove
old faucet. Clean sink surface in preparation
for new faucet.
If you model has a spray, proceed to step 2.
If you model does not have a spray skip to
step 4.
For models with spray ( fits 4 - hole sinks ):
Insert spray suppor through far right - hand
hole on sink. Screw hold - down nut onto
shank and hand tighten.
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8 in. O.D. ball-nose riser
(1, not included). Use wrenches when
tightening. Do not overtighten.
Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
6.
4.
2.
5.
3.
1.
INSTALLATION STEPS: Two handle kitchen faucet
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
INSTALLATION
Model Number: 120445LF & 120446LF & 120447LF & 120448LF
3
1
2
Brand Lavatory Faucets
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty