Installation Guide

Shut off water supply at angle stop. Remove
old faucet. Clean sink surface in preparation
for new faucet.
Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
3.
2.
1.
INSTALLATION STEPS: Two handle bar faucet
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
INSTALLATION
Model Number: 119281 & 119282
4.
Place new faucet in position on sink. From
under sink, thread mounting nuts (1) onto
faucet. Tighten mounting nuts.
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8 in. O.D. ball-nose riser (1,
not included). Use wrenches when tightening.
Do not overtighten.
1
1
3
2
Brand Lavatory Faucets
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty