Use and Care Manual

OPERATING YOUR RANGE DURING AN

ELECTRICAL POWER FAILURE

WARNING: USE EXTREME CAUTION WHEN LIGHTING BURNERS THIS WAY

LIGHTING TOP BURNERS

1. Hold a lighted match to the desired burner head.

2. Push and turn the control knob to the “LITE” or

“START” position.

3. After burner lights, adjust flame to desired size

as required.

LIGHTING OVEN BURNER

1. Remove the oven bottom (See page 11). After removing

the oven bottom, remove the oven burner baffle plate from

the top of the oven burner.

2. Rotate the knob to the “PILOT” or “LITE” position.

Push in and hold the oven control knob.

3. Place a lit match or lighter at the pilot to light it. Con-

tinue to hold in on the control knob for 10 seconds. See

drawing.

4. After the 10 sec. hold period release the knob. The pilot

flame should remain lit. Once the pilot is lit, replace the

burner baffle and oven bottom. If the oven pilot does not

remain lit repeat steps 2-4.

5. Push in and rotate the oven control knob to the desired

baking temperature. Upon selecting the cooking tempera-

ture, open the oven door to observe that the burner flame

has lit by looking through the observation hole in the front

center of the oven bottom.

6. The oven will continue to cook normally until the Oven

Control Knob is rotated to the “OFF” position.

TOP BURNER

OVEN BURNER

NOTICE: The surface and oven burners in use when an electrical power failure occurs will continue to

operate normally until shut off.

LIGHTING OVEN BURNER

Before attempting to light the oven burner, it is important to determine whether the oven in your range will

operate during an electrical outage. To make this determination it is necessary to identify the type of oven sys-

tem that your range employs. The easiest way to check this is to look at the first letter of your range model

number. If your range model number starts with an “S” it can not be operated during a power outage.

Refer to the back cover of your manual to find the location of the model number rating plate. Follow the oven

lighting instruction below if your range model number starts with a “T”.