Use and Care Manual

CONVERTING RANGE FROM NATURAL GAS
TO L.P. (PROPANE) GAS
STEP 3 METHOD A Convert the Range Oven thermostat.
The oven thermostat control is at the center front of the
range located behind the oven control knob and control panel.
Locate the brass LP (propane) gas conversion screw on the
right side of the oven thermostat as shown in Fig. 4
This screw can be accessed through a hole in the control
panel.
1. Turn the conversion screw clockwise until seated tight into
the oven thermostat control.
2. After the conversion screw has been converted, the oven
pilot flame must be adjusted. In order to properly set the
pilot it is necessary to remove the oven bottom (See page
11 for the oven bottom removal).
GAS CONVERSION SCREW
OVEN THERMOSTAT CONTROL
(located behind the oven control knob and
control panel)
Fig. 4
22
3. Remove the oven burner baffle by removing the wing nut
that holds the baffle to the oven burner. With the baffle
removed, the oven pilot can be observed on the right rear
side of the oven burner.
4. Before adjusting the oven pilot, the pilot has to be lit.
In order to light the oven pilot, rotate the control knob to
the “PILOT” or “LITE” position and push and hold in on
the knob. Hold knob for approximately 10 sec. before
releasing it. The pilot should remain lit. Repeat step 4 if
pilot goes out.
PILOT ADJUSTMENT SCREW
OVEN THERMOSTAT CONTROL
(located behind the oven control knob and
control panel)
STEP 2 METHOD A or METHOD B Convert top burners:
To convert burners from Natural Gas to L.P. (propane) the burner orifices must be replaced with a set of ori-
fices packed separately with the unit.
A. Remove the burner caps. This requires no tools.
B. Remove the Natural Gas orifice by reaching down into the center of the burner with a 5/16” nut driver.
C. Rotate the orifice counter-clockwise to remove and replace with the proper L.P. replacement.
D. Use the description to identify the proper orifice for the proper size burner.
Fig. 5