Use and Care Guide

INSTALLATION INSTRUCTIONS
INSTALLING THE DC POWER PACK
Before any of the burners can be lighted, it is
necessary to locate the power pack that is located
in the range oven section. The power pack re-
quires (8) AA size batteries. It is recommended
that a good quality Alkaline Battery be used.
Insert the batteries as described on the case. Af-
ter loading the battery pack, insert the pack into
the battery case located at the lower front corner
of the range. Screw the power supply cover to
the battery case with the screws provided. Do
not over tighten.
REPLACING WEAK BATTERIES
1. Remove two screws holding battery case/cover in place. Note: The battery case is located in the front low-
er corner of the range.
2. Slide the cover/case out of the unit.
3. Replace the weak batteries with (8) fresh Double A Alkaline type batteries paying note to the battery in-
structions printed on the case.
4. Slide the case back into the unit with the arrows on the case cover facing up.
5. Replace two screws holding cover in place.
(8) AA Alkaline Batteries
Arrows pointing up when
inserting battery case
POWERING CORDLESS RANGES (SOME MODELS)
It is not necessary to connect your range to a plug-in outlet in your home. The burner ignition comes from a
DC source (battery power pack).
20