Use and Care Guide
CONVERTING RANGE FROM PROPANE GAS TO
NATURAL GAS
STEP 3 METHOD A Convert the Range Oven ther mostat.
The oven thermostat control is at the center front of the
range located behind the oven control knob and control panel.
Locate the brass gas conversion screw on the right side of the
oven thermostat as shown in Fig. 4
This screw can be accessed through a hole in the control
panel.
1. Turn the conversion screw counter-clockwise 360 degrees,
one full turn.
2. After the conversion screw has been converted, the oven
pilot flame must be adjusted. In order to properly set the
pilot it is necessary to remove the oven bottom (See page
10 for the oven bottom removal).
GAS CONVERSION SCREW
OVEN THERMOSTAT CONTROL
(located behind the oven control knob and
control panel)
Fig. 5
25
3. Remove the oven burner baffle by removing the wing nut
that holds the baffle to the oven burner. With the baffle
removed, the oven pilot can be observed on the right rear
side of the oven burner.
4. Before adjusting the oven pilot, the pilot has to be lit.
In order to light the oven pilot, rotate the control knob
to the “PILOT” or “LITE” position and push and hold
in on the knob. Hold knob for approximately 10 sec.
before releasing it. The pilot should remain lit. Repeat
step 4 if pilot goes out.
PILOT ADJUSTMENT SCREW
OVEN THERMOSTAT CONTROL
(located behind the oven control knob and
control panel)
Fig. 4
STEP 4 METHOD B No Oven Ther mostat conversion is r equir ed.
5.Once the pilot is lit, locate the pilot adjustment
screw on the lower left hand side of
the oven thermostat control. See Fig. 5
Access the pilot adjustment screw through
the opening behind the oven temperature con-
trol knob. With a straight blade screwdriver ro-
tate the screw till the outer tip of the flame is
just barely reaching the underside of the end of
the flame safety probe. See Fig. 6.
FLAME SAFETY PROBE
OVEN PILOT
Fig. 6
STEP 5 METHOD A or METHOD B Check Oper ation:
After the above conversion has been completed, check operation of cooktop and oven burner. Make air shutter
adjustments and set cook top pilots if necessary (See Page 27 for lighting and burner adjustments.).