Installation Instructions

SURFACE COOKING

BURNER LIGHTING SOURCE

The burners on your range need an electrical source to ignite the

burners. The electricity required to light the burners may come

from an electrical outlet or from a battery power pack. Ranges

without a power cord have a battery power pack located in the

lower right corner of the range.

In either case your new range is equipped with automatic igni-

tion top burners. Each burner can be controlled to provide heat

from the highest “full on” to the very low “keep warm”. The

burner knob can be set to any position for the flame desired.

TO LIGHT A SURFACE BURNER

Push the control knob in and turn it to the LITE or START position. You will hear a clicking noise– the sound

of the electric spark. After the burner ignites, turn the knob to adjust the flame size. NOTE: ALL IGNITORS

WILL SPARK WHEN ANY CONTROL KNOB IS TURNED TO THE LITE POSITION.

CONTROL PANEL located on front of range to allow easy reach of all range controls.

A. LIGHT SWITCH ( OPTIONAL ) B. RIGHT FRONT CONTROL KNOB C. RIGHT REAR CONTROL KNOB

D. OVEN CONTROL KNOB E. GRIDDLE CONTROL KNOB-OPT. F. LEFT FRONT CONTROL KNOB

G. LEFT REAR CONTROL KNOB H. SURFACE BURNER LOCATION INDICATOR

F C B A G E D H

FOR BEST RESULTS

The gas burner adjust to any flame desired and al-

lows you to tailor the flame to fit any pan large or

small.

Always position the utensil on the burner grate BE-

FORE lighting the burner. FOR YOUR SAFETY,

the flame should not extend beyond the sides of the

pan.

POWER PACK