INSTALLATION MANUAL PBC-UMS . Premier Mounts 3130 E. Miraloma Avenue Anaheim, CA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 www.mounts.com mounts@mounts.com Rev.
PBL-110 Projector Mount Page 2 Installation Manual
PBC-UMS Table of Contents Warning Statements ..................................................................................................................................................................... 4 Parts List ........................................................................................................................................................................................ 5 Installation Tools .................................................................................
PBC-UMS Warning Statements WARNING: THE CEILING STRUCTURE MUST BE CAPABLE OF SUPPORTING 25 LBS. IF NOT, THE CEILING MUST BE REINFORCED. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE INSTALLATION INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY, OR EVEN DEATH. WARNING: SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE INSTALLATION OF THIS PRODUCT.
PBC-UMS Parts List NOTE: This mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the installation and contact Premier Mounts (800) 368-9700.
PBC-UMS A B C D E F G H I J K L M Single Wooden Stud Mounts Solid Structure Mounting Points M3 Allen Wrench Allen Wrench 1.5” Nipple (NTP) Tension Knobs Safety Knob Security Screws Leveling Screws Universal Mounting bracket Leg Assembly Projector (not included) Tri-Lock Opening Option 1 A B C D E F G H K NOTE: The four (two-piece) leg assemblies can be used as single leg or any combination of single and dual legs together as shown in Options 1 and 2.
PBC-UMS Features Congratulations on your recent purchase of the your PBC-UMS universal projector ceiling mount kit. This unit is designed for projectors weighing 25lbs. (13kg) or less. The mount is easy to install and is loaded with additional installation features built into the mount. These features allow you to optimize the projector’s position to the screen for the best projector performance and picture quality.
PBC-UMS Projector Preparation CAUTION: NOTE: 1. 2. THE PROJECTOR IS FRAGILE; HANDLE WITH CARE AT ALL TIMES. Review the projector manufacturers operation manual and refer to the ceiling mount installation section. Important information concerning the installation dimensions (i.e. distance from the screen to the lens of the projector, top of the lens placement to the top screen, etc.) will be found in this section.
PBC-UMS B A Upper Assembly Tension Knobs Safety Knob Rotate 180° To unlock Tri-Lock Opening C Figure 2.
PBC-UMS Bracket Installation NOTE: The two-piece mounting kegs are designed to allow for the positioning of each leg around projector air vents located on the base of the projector. Where applicable, each leg mount may be shortened by removing the locking screw. This will allow for a better bracket fit, overall. NOTE: For easier installation, the mounting legs should be first mounted to the projector. Each leg should then be adjusted so that they can mount to the Universal Mount (Figure 3). 1.
PBC-UMS Leveling the Mounting Bracket CAUTION: 1. 2. 3. Secure but do not over tighten the mounting hardware. Failure to do so will result in damaging the threads in the projector. Rotate the leveling barrels to level the mounting bracket. Position the mounting bracket so that it avoids most, if not all, ventilation points (including lamp and filter access doors).
PBC-UMS Securing the Upper Assembly Ceiling Plate Review your projector’s owner’s manual to determine what distance is recommended from the front of the lens to the edge of the screen for best picture ratio. NOTE: However in most home theater and office ceiling mount installations this is not practical as the projector would be to low within the room.
PBC-UMS Securing the Projector to the Upper Assembly 1. 2. 3. 4. Make sure the three-knurl knobs are loosened to fully expose to the “tri-lock” mounting plate in the base of the upper assembly. Carefully lift the projector and insert the mounting bracket mating special tri-lock cutout into the mating portion of the upper assembly. Once inserted rotate the projector and mounting bracket 180° and secure the rear safety knob first to prevent further rotation of the bracket in the upper assembly.
PBC-UMS Final Adjustments 1. With the projector secured in the mount and power on and signal supplied to the projector you can now proceed with the final height, tilt, roll and yaw to optimize the projected image. A Wooden Stud The height can be adjusted by rotating the PBC clockwise (higher) / counterclockwise (lower). Once the height is achieved, tighten the locking set screw using the supplied Allen Wrench.
PBC-UMS Plastic Cap Installation 1. Once all the final adjustments have been finished, install the plastic caps on the leveling barrels (Figure 8). Figure 8.
PBC-UMS Troubleshooting Procedures QUESTION: ANSWER: QUESTION: ANSWER: Page 16 My projector mount must be set at an angle to be viewed properly on the wall, but the projector will not hold at this position. Why is this? The angle adjustments are not tight; they must be tightened. Why won’t my bracket fit my projector? There may be several mounting positions for your particular bracket. Try to line up the holes on the bracket with the mounting points on the projector.
PBC-UMS Technical Specifications Figure 9.
PBC-UMS Warranty Limited Lifetime Warranty All products carry a limited lifetime warranty from ship date against defects in materials and workmanship. Premier Mounts is not liable for improper installation that results in damage to mounts, adapters, display equipment or personal injury. Contact Premier Mounts In the event of missing and/or damage equipment, or technical questions, the following information can help in the completion of the installation.
PBC-UMS Notes R LISTED E176225 Premier Mounts 3130 E. Miraloma Avenue Anaheim, CA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 www.mounts.com mounts@mounts.com Rev.