Service manual

Page 10

Thread the plastic elbow (supplied in the parts bag) onto the

stainless steel connection on the top of tank. Tighten using an

adjustable wrench. Do not over tighten as plastic could crack.

Step 17

Step 18

Wrap (7 to 12 turns) Teﬂon tape clockwise around the male pipe

threads (MPT) on the Stainless Steel ﬁtting on top of the tank.

Tank Elbow Installation - Part# 125032

Do not Teﬂon tape the plastic elbow threads as this may

cause leaks.

Caution:

Do not let the tape cover the opening.Note:

Drain Saddle ﬁts standard 1 ¼” – 1 ½” drain pipes

Drain Saddle Installation - Part# 164016

Step 14

Step 15

Step 16 Drill a ¼” hole through the drain pipe at least 1 ½” above the nut

of the P-trap to allow for the removal of the P-trap if necessary.

Assemble the drain saddle around the drain pipe. Position the

drain saddle over the drilled hole in pipe. Insert screw driver

into the opening of the drain saddle and align with drilled hole

in drain pipe. Using Philips screw driver tighten screws evenly

and securely on both sides of the drain saddle. Attach black

compression nut, but do not tighten at this time. The black tubing

will be installed later.

The small square black foam gasket with a circle cut out of the

middle must be applied to the inside of the drain saddle. Remove

sticky tape backing and stick to the drain saddle as shown.

1 Black compression nut

1 Semicircle bracket with opening

2 Screws

1 Foam washer

2 Nuts for screws

1 Semicircle bracket

Gather the pieces of the drain saddle

Caution: Do not over tighten the screws. It may crack the drain saddle.