Service manual

Page 11

Connect Blue Tube from TANK port on RO Module to the Tank

Position tank in desired location. Stand it upright or lay it on its

side (using the black plastic stand). Measure the blue tube from

the RO module port marked TANK over to the tank and cut it to

desired length.

Insert the blue 3/8” tube into the compression nut as far as it

will go. Tighten the compression nut securely with a wrench.

Step 23

Step 22

Green Tube Connection

Connect the green tube from the RO module to the adapta

valve that is connected to the Angle Stop Valve. Leave

enough tube so it is not kinked and cut the tube to desired

length.

Step 19

Step 21

Step 20

Adapta Valve - Part # 134007

Remove a brass nut, plastic sleeve and brass insert from the

parts bag. Place nut on the tube ﬁrst, then the sleeve (Small

taper end of sleeve must point to the end of tube) and then

insert the brass Insert into the end of the tube.

Insert the green tube into the ¼” opening on the adapta valve until it stops. Slide nut and

sleeve down and thread onto the male pipe threads. Use a ½” wrench to securely tighten.