Service manual

Page 13
Thread the larger (3/8”) white plastic connector into the other end
of the final filter.
Step 29 Thread the smaller (1/4”) white plastic connector into the end of
the Final Filter and tighten , (flow arrow on filter points to the 1/4”
connector).
Step 30
The Final Filter and 2 white plastic connectors are in the parts
bag. (One 1/4” smaller & one 3/8” larger)
Remove the caps from the final filter.
Final Filter Installation
Step 28
Step 27
Step 26
Connect the Red Tube from Faucet to RO Module
Insert the red 1/4” tube from the faucet into the port on the
module marked DRAIN. Make sure the tube is pushed in all
the way to the tube stop.
Insert the 1/4” blue tube attached to the faucet into the outlet of
the filter and tighten plastic nut securely. The flow arrow should
be pointing toward the faucet. Insert the 3/8” blue tube attached
to the module into the 3/8” inlet white connector on the in-line
Final Filter. Tighten the white compression nuts with an
adjustable wrench.
Step 31