Instruction manual

P-10
4. SYSTEM SETUP (DVD ONLY)
Please follow the below steps to enter the System Page: First, power on the unit with the disc
tray is empty or the disc door is opened, then press SETUP button and enter the System
Page by pressing NAVIGATION buttons. Or during playback, press STOP button twice, and
then press SETUP button to enter system setup page.
4.1 TV TYPE - it is used to select the TV mode.
Please select this option as per your TV set.
4.2 AUDIO - select preferred audio language.
(DVD only - need disc software support)
4.3 SUBTITLE - select preferred subtitle language.
(DVD only - need disc software support)
4.4 DISC MENU - select preferred disc menu language.
(DVD only - need disc software support)
4.5 PARENTAL - select rating levels.
(DVD only - need disc software support)
4.6 PASSWORD
Option: Change - Select it to change password.
Procedure to change password as following:
1) Enter old password in the Old Password row
2) Enter new password in the New Password row
3) Enter the new password again in the Confirm Pwd row
The user password is "0000". You may reset the password if you forget the old password by
using the supervisor password: 1389
4.7 DEFAULT - Reset to factory settings.
DISC HANDLING PRECAUTIONS
y Hold the disc by the edge so the surface will not be soiled with finger prints.
Finger prints, dirt and scratches can cause skipping and distortion.
y Do not write on the label side with a ball-point pen or other writing utensils.
y Do not apply benzine, thinner, and liquid that prevents against static electricity.
y Be careful not to drop or bend the disc.
y Install only one disc on the disc tray.
y Do not try to close the disc tray when the disc is not installed properly.
y Be sure to store the disc in its case when not in use.
SPECIFICATIONS
Power source: AC 100-240V~ 50/60Hz
DC: 9V-12V
Power consumption: 10W
Operating Temperature Range: +5
o
C to +35
o
C
Continuous playing time: 120 minutes
Dimensions: 208(L) x 167.6(W) x 38.80(H)mm
Operating Humidity Range: 10 % to 75 %