Installation Instructions
1. Place the door on saw horses
with the hinge knuckles up.
2. After removing the
retaining clip and frame
spacers, open the door.
3. Remove the nine hinge screws
from the door panel.
4. Lift and turn the panel end for
end. Do not move the frame.
5. Flip the panel over to
re-attach the hinges.
6. Install the nine hinge screws
which were removed in step 3.
Install the parting stop at the
top of the door frame. Install
the sweep at the bottom
of the door panel.
8. Close the door panel back
into the frame and replace
frame spacers.
Door units should be installed
before the steel is applied. For
best results, the side of the door
should be located between the
ribs of the steel.
1. Nail (2) 2x4 vertical nailer onto the inside of
the girts (RO width +3”).
2. Nail a 2x4 horizontal nailer onto the outside
of the vertical nailer (RO height +1-1/2”).
3. Cut out girts between vertical nailer.
4. Nail a 2x4 horizontal jamb to the bottom of
the horizontal nailer.
5. Nail 2x4 vertical jambs to insides of the
vertical nailer.
6. Add 2x4 spacer blocks, cut to t,
between girts.
7. Insert the door into the frame-out and fasten
it in place from the outside.
NOTE: Doors without windows may be rotated and turned to achieve the desired swing without removing the frame.
NOTE: If 2x4 framing is not followed or the door is installed for inswing application, additional trim may be required.
1.
3.
4.
6.
5.
7.
1. 5.
6.
7.
2.
3.
4.
2.
Hinge Reversing Procedure for
Prehung 4-Way Doors with Factory Installed Window
Service Door Installation
2x4 Spacer BlocksVertical Nailer
Rough Opening
Rough
Opening
Girt
Girt
Treated Post
2x4 Jamb (Included)
TOP VIEW
FRONT VIEW
Vertical Nailer
Vertical Nailer
Rough Opening
Rough
Opening
Girt
Girt
Treated Post
2x4 Jamb (Included)
TOP VIEW
FRONT VIEW
2x4 Spacer Blocks
Vertical Nailer
Horizontal Nailer
Rough Opening
Rough
Opening
Girt
Girt
Treated Post
2x4 Vertical Jamb
TOP VIEW
FRONT VIEW
2x4 Spacer Blocks
www.MidwestManufacturing.com