INSTALLATION INSTRUCTIONS Before Using Your Freezer Remove the exterior and interior packing. Check to be sure you have all of the following parts: 1 Storage Basket 1 Instruction Manual 1 Plastic Scraper(optional) Before connecting the freezer to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth.
Defrosting Your Freezer When? For the most efficient operation and minimum energy consumption, defrost the freezer when the frost on the freezer walls is excessive or 5 to 10 mm thick. Choose a time when the stock of frozen food is low.
freezer, just slide the basket to one side, or lift it out. CARE AND MAINTENANCE Cleaning Your Freezer Upon installation of your new appliance, it is recommended that it be cleaned thoroughly. Turn the temperature control to "OFF", unplug the freezer, remove the food and storage basket. Wash the inside with a damp warm cloth containing a water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. Wash the storage basket with a mild detergent solution.
suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE ÐÎÑÞÔÛÓ ÐÑÍÍ×ÞÔÛ ÝßËÍÛ Freezer does not operate. Not plugged in. The circuit breaker tripped or a blown fuse. The freezer temperature control is set at "0/OFF". Compressor turns on and off frequently. The room temperature is hotter than normal. A large amount of food has been added to the freezer. The door is open too often. The door is not closed completely.
Bubbling or gurgling sound, like water boiling. Refrigerant (used to cool freezer) is circulating throughout the system. This is normal. Vibrations. Check to assure that the freezer is level. Floor is uneven or weak. Freezer rocks on the floor when it is moved slightly. adequately support freezer. Be sure floor can Level the freezer by putting wood or metal shims under part of the freezer. The freezer is touching the wall. Re-level the freezer and move it from the wall.
