Transportation and Placement △ When transporting the chest freezer from one place to another, the inclination of the cabinet should not exceed 45 degrees, for prevention against compressor or system damage. △ Before use, remove all the packing material. The back side of the cabinet should be more than 20cm away from the wall, both sides more than 20cm away from any adjacent cabinet or wall. △ The freezer should be put in a well-ventilated, dry place. Do not place it under direct sunshine.
△ Do not use boiling water, acid, chemical diluents, petrol and oil, or dirtremoving powder. △ Dry it after cleaning. △ Use light soapy water when cleaning the door seal, apply a little talcum powder on it after natural drying to extend its service life. △ Use a soft cloth with water or a little detergent to clean the external surface. Note, keep the power supply, electric cable and plug away from water to avoid electric shock.
The noise is too loud The freezer is not placed on an even surface. The fixing of the freezer is loose. There is contact between pipes. Place it on an even surface. Tighten the fixing. Separate them. The following are not faults: △ When the freezer is working or after it stops for a while, the refrigerant in the pipes is cycling and makes “running water"sounds. △ The surface temperature of the compressor may be up 70 o~80o when it is working. △ The back side of freezer is hot.
Congelador Horizontal Transporte y colocación Al transportar el congelador de un lugar a otro, la inclinación del electrodoméstico no debe exceder los 45°, para prevenir daños al compresor y/o al sistema. Antes de utilizar, se debe remover todo el empaque. La cara posterior del electrodoméstico debe quedar a 20 cm. de la pared, los lados posteriores deben estar por lo menos a 20 cm. de cualquier objeto. El congelador debe ser colocado en un lugar con suficiente ventilación.
temperatura cuando la temperatura en el compartimiento esté bajo cero. Aquellos alimentos que deben estar libres de humedad o que pierden agua fácilmente, deben ser almacenados en bolsas o recipientes herméticos antes de colocarlos en el congelador para evitar malos olores y la formación de escarcha. Se prohibe el almacenamiento de gases volátiles y/o combustibles así como de líquidos alcalinos fuertes, líquidos ácidos fuertes, gasolina etc.
El indicador está encendido pero el compresor no funciona y emite zumbidos El voltaje de alimentación es menor a 98V El compresor se de tiene por un rato después de comenzar, y luego vuelve a empezar.