Installation Guide

Maintenance and

Disassembly

 Page 36 

2. Electrical parts (Antistatic gloves must be worn.)

Note: Remove the front panel (refer to 1. Front panel) before disassembling electrical parts.

Procedure Illustration

1) Cut the ribbon by a shear, then pull

out the coil temperature sensor (T2)

(see CJ_AB_INV_014).

2) Remove one ﬁxing screw of the

electronic control box and two screws

used for the ground connection (see

CJ_AB_INV_014).

3) An upward force is maintained until

the cover of electronic control box is

removed (see CJ_AB_INV_015).

CJ_AB_INV_014

CJ_AB_INV_015

Note: This section is for reference only. Actual unit appearance may vary.

Ribbon

T2 Sensor

Ground Screws