Instructions / Assembly

3
¾ REVERSING THE DOOR SWING OF YOUR ICE MAKER
THIS APPLIANCE HAS THE CAPABILITY OF THE DOOR OPENING FROM EITHER THE LEFT OR
RIGHT SIDE. THE UNIT IS DELIVERED TO YOU WITH THE DOOR OPENING FROM THE LEFT
SIDE. SHOULD YOU DESIRE TO REVERSE THE OPENING DIRECTION, PLEASE CALL
CUSTOMER SERVICE FOR REVERSAL INSTRUCTIONS.
OPERATING YOUR ICE MAKER
¾ INITIAL START-UP OPERATION
1. PLUG
THE APPLIANCE INTO A 115/120V POLARIZED AND GROUNDED WALL ELECTRICAL
OUTLET.
2. PLACE
THE ON-OFF SWITCH IN THE “ON” POSITION.
3. MAKE
SURE THE WATER SUPPLY IS ON. AS SOON AS THE INNER MECHANISM REACHES
THE PROPER TEMPERATURE, THE ICEMAKER MECHANISM WILL FILL THE MOLD WITH
WATER.
4. THE
FIRST CUBES MAY BE SMALL BECAUSE OF AIR IN THE WATER LINE. LATER CUBES
WILL BE OF STANDARD CRESCENT MOON TYPE SIZE.
5. APPROXIMATE
TIME FOR THE FIRST CYCLE IS BETWEEN 30-40 MINUTES.
6. EACH
CYCLE APPROXIMATELY WILL TAKE 140 ML OF WATER SO YOU SHOULD HAVE A
FULL TRAY, AFTER 11 HOURS.
IMPORTANT:
THROW AWAY ALL ICE CUBES MADE DURING THE FIRST 3 HOURS OF
OPERATION.
• WHEN
THE ICE BUCKET IS FULL, THE ICE MAKING MECHANISM WILL
AUTOMATICALLY SHUT OFF. HOWEVER THE SYSTEM WILL CONTINUE TO
COOL AND MAINTAIN THE CUBES SUPPLY.
• ICE
DELIVERY MAY BE INTERRUPTED BY RAISING THE METAL ARM INTO
AN UPRIGHT POSITION (SEE SKETCH 2)
• IF
THE ICEMAKER IS NOT USED REGULARLY, IT IS RECOMMENDED THAT
THE ICE BUCKET BE EMPTIED PERIODICALLY TO INSURE FRESH ICE.
• SOMETIMES
THE CUBES MAY APPEAR CLOUDY. THIS IS CAUSE OF NO CONCERN AND HAS
NOTHING TO DO WITH THE TASTE OR CHEMICAL MAKE-UP OF THE WATER.
• THE
FRONT GRILL SHOULD BE KEPT FREE OF DUST AND LINT TO PERMIT FREE AIRFLOW.
• THIS
UNIT SHOULD BE DEFROSTED APPROXIMATELY EVERY 4-6 WEEKS OR WHEN FROST
ON THE ICE MAKER WALLS IS EXCESSIVE OR ¼” THICK. TO DEFROST, TURN THE UNIT OFF,
REMOVE CUBES AND KEEP DOOR OPEN AT LEAST TWO INCHES.
CARE AND MAINTENANCE
¾ CLEANING YOUR ICE MAKER
• TURN
THE SWITCH CONTROL TO "OFF", UNPLUG THE ICE MAKER AND REMOVE BUCKET.
• WASH
THE INSIDE WITH A WARM WATER AND BAKING SODA SOLUTION. THE SOLUTION
SHOULD BE ABOUT 2 TABLESPOONS OF BAKING SODA TO A QUART OF WATER.
• WASH
THE BUCKET WITH A MILD DETERGENT SOLUTION.
• THE
OUTSIDE OF THE ICE MAKER SHOULD BE CLEANED WITH MILD DETERGENT AND
WARM WATER.
• THE
CONDENSER COILS SHOULD BE VACUUMED WHEN THEY ARE DUSTY OR DIRTY.
SKETCH 2