Instructions / Assembly

4
CAUTION
FAILURE
TO UNPLUG THE ICE MAKER COULD RESULT IN ELECTRICAL SHOCK OR
PERSONAL INJURY.
¾ POWER FAILURE
MOST
POWER FAILURES ARE CORRECTED WITHIN A FEW HOURS AND SHOULD NOT AFFECT
THE TEMPERATURE OF YOUR ICE MAKER IF YOU MINIMIZE THE NUMBER OF TIMES THE DOOR
IS OPENED. IF THE POWER IS GOING TO BE OFF FOR A LONGER PERIOD OF TIME, YOU NEED
TO TAKE THE PROPER STEPS TO DISCONNECT YOUR APPLIANCE.
¾ VACATION TIME/STORAGE
1. SHUT
OFF WATER SUPPLY AT THE MAIN WATER VALVE.
2. DISCONNECT
THE WATER SUPPLY LINE FROM VALVE.
3. ALLOW
UNIT TO RUN FOR AN HOUR OR TWO UNTIL ALL REMAINING ICE CUBES HAVE
BEEN EJECTED.
4. DISCONNECT
UNIT FROM MAIN POWER SOURCE.
5. DRY
OUT EXCESS WATER FROM ICE MAKER ASSEMBLY
6. LEAVE
THE DOOR OPEN AT LEAST TWO INCHES.
¾ MOVING YOUR ICE MAKER
• SECURELY
TAPE DOWN ALL LOOSE ITEMS INSIDE YOUR ICE MAKER.
• TURN
THE LEVELING SCREWS UP TO THE BASE TO AVOID DAMAGE.
• TAPE
THE DOOR SHUT.
• BE
SURE THE ICE MAKER STAYS IN THE UPRIGHT POSITION DURING TRANSPORTATION.
¾ ENERGY SAVING TIPS
• THE
ICE MAKER SHOULD BE LOCATED IN THE COOLEST AREA OF THE ROOM, AWAY FROM
HEAT PRODUCING APPLIANCES OR HEATING DUCTS, AND OUT OF THE DIRECT
SUNLIGHT.