Installation Guide

IMPORTANT:

Double check that both doors are aligned correctly and gaskets are sealed on

all sides. If necessary, re-adjust the leveling legs.

Remove right pin assemblies from the bottom of

the freezer and refrigerator doors. On the

opposite side, attach the replacement pin

assemblies(located in the plastic bag with the Use

and Care Manual) with a screwdriver.

Note: You must re-use the screws from the pin

assemblies that are removed in this step when

attaching the new assemblies

Place the refrigerator door on the bottom left

hinge. Ensure the door is aligned horizontally

and vertically, and that the gasket seals on all

sides before attaching the middle hinge. Attach

the middle hinge using a screwdriver.

Place the freezer door on the middle hinge.

Ensure that the door is aligned horizontally

and vertically, and that the gasket seals on all

sides before attaching the top hinge. Attach

the top hinge and replace the hinge cover.