SDS

PRESERVA
®
WOOD STAIN 250 VOC MSDS
PAGE 7 OF 9
12. ECOLOGICAL INFORMATION
ALL WORK PRACTICES MUST BE AIMED AT ELIMINATING ENVIRONMENTAL CONTAMINATION.
MOBILITY: This product has not been tested for mobility in soil, but is expected to be highly mobile.
PERSISTENCE AND BIODEGRADABILITY: This product has not been tested for persistence or biodegradability. Some
biodegradation is expected due to the organic oil components.
BIO-ACCUMULATION POTENTIAL: This product has not been tested for bio-accumulation potential.
ECOTOXICITY: This product has not been tested for aquatic toxicity; all release to the environment should be avoided.
OTHER ADVERSE EFFECTS: This product does not contain any component with known ozone depletion potential.
ENVIRONMENTAL EXPOSURE CONTROLS: Controls should be engineered to prevent release to the environment, including
procedures to prevent spills, atmospheric release and release to waterways.
13. DISPOSAL CONSIDERATIONS
WASTE TREATMENT/DISPOSAL METHODS: It is the responsibility of the generator to determine at the time of disposal whether the
product meets the criteria of a hazardous waste per regulations of the area in which the waste is generated and/or disposed of. Waste
disposal must be in accordance with appropriate Federal, State, and local regulations. This product, if unaltered by use, may be disposed
of by treatment at a permitted facility or as advised by your local hazardous waste regulatory authority. Shipment of wastes must be done
with appropriately permitted and registered transporters.
DISPOSAL CONTAINERS: Waste materials must be placed in and shipped in appropriate 5-gallon or 55 gallon poly or metal waste
pails or drums. Permeable cardboard containers are not appropriate and should not be used. Ensure that any required marking or labeling
of the containers be done to all applicable regulations.
PRECAUTIONS TO BE FOLLOWED DURING WASTE HANDLING: Wear proper protective equipment when handling waste
materials. Dispose of in accordance with applicable Federal, State, and local procedures and standards.
U.S. EPA WASTE NUMBER: Wastes of this product should be tested for waste characteristic ignitability (D001).
14. TRANSPORTATION INFORMATION
U.S. DEPARTMENT OF TRANSPORTATION REGULATIONS: This product can be classified as dangerous goods, per U.S. DOT
regulations, under 49 CFR 172.101. NOTE: The classification of Combustible liquid, n.o.s. applies only to shipments of this product via
ground within the United States. There is no classification for ‘Combustible Liquid’ under Canadian TDG, IATA or the IMO.
PROPER SHIPPING NAME: Combustible liquid, n.o.s. (mineral spirits, vegetable oils)
HAZARD CLASS NUMBER and DESCRIPTION: Combustible Liquid
UN IDENTIFICATION NUMBER: NA 1993
PACKING GROUP: III
DOT LABEL(S) REQUIRED: No label is required for a material classed as a combustible liquid
SPECIAL PROVISIONS: IB3, T1, T4, TP1
PACKAGING: Exceptions: 150; Non-Bulk: 203; Bulk: 241
QUANTITY LIMITATIONS PASSENGER AIRCRAFT: 60 L
QUANTITY LIMITATIONS CARGO AIRCRAFT: 220 L
VESSEL STORAGE: Location: A; Other: None.
NORTH AMERICAN EMERGENCY RESPONSE GUIDEBOOK NUMBER, 2008: 128
MARINE POLLUTANT: No component is classified as a Marine Pollutant, per Appendix B to 49 CFR 172.101
This product can be reclassified as an ORM-D material and marked as follows:
PROPER SHIPPING NAME: Consumer Commodity
HAZARD CLASS NUMBER and DESCRIPTION: ORM-D
UN IDENTIFICATION NUMBER: None
PACKING GROUP: None
DOT LABEL(S) REQUIRED: No label is required for ORM-D materials.
SPECIAL PROVISIONS: None
PACKAGING: Exceptions: 150; Non-Bulk: 306; Bulk: None
QUANTITY LIMITATIONS PASSENGER AIRCRAFT: 30 kg gross
QUANTITY LIMITATIONS CARGO AIRCRAFT: 30 kg gross
VESSEL STORAGE: Location: A; Other: None.
ORM-D INFORMATION:
(a) Each non-bulk packaging containing a material classed as ORM–D must be marked on at least one side or end with the ORM–D designation
immediately following or below the proper shipping name of the material. The ORM designation must be placed within a rectangle that is
approximately 6.3 mm (0.25 inches) larger on each side than the designation. The designation for ORM–D must be:
(1) ORM–D–AIR for an ORM–D that is prepared for air shipment and packaged in accordance with the provisions of 49 CFR § 173.27.
(2) ORM–D for an ORM–D other than as described in paragraph (a)(1) of this section.
(b) When the ORM–D marking including the proper shipping name can not be affixed on the package surface, it may be on an attached tag.
(c) The marking ORM–D is the certification by the person offering the packaging for transportation that the material is properly described,
classed, packaged, marked and labeled (when appropriate) and in proper condition for transportation according to the applicable regulations of
this subchapter. This form of certification does not preclude the requirement for a certificate on a shipping paper when required by subpart C
of this part.
TRANSPORT CANADA, TRANSPORTATION OF DANGEROUS GOODS REGULATIONS: This product is NOT classified as
Dangerous Goods, per regulations of Transport Canada.