Owner's Manual

21
- The charge begins. appears on the display to indicate charging
mode and
indicates the charging level.
-
disappears when the unit is fully charged.
3) CHANGING THE BATTERY PACK
The battery pack is pre-installed in the unit. If you need to replace
the battery pack :
1. Unscrew the battery pack door (E). If necessary, remove the belt
clip (C5) or the microphone support (C4) to reach the screw.
2. Disconnect and remove the old battery pack.
3. Connect the new battery pack.
4. Screw then the battery pack door (E).
Note: The battery pack is provided uncharged, so you must
charge the battery pack before using it with the transceiver.
4) LOW BATTERY FEATURES
When the battery is uncharged the RX/TX LED (16) blinks yellow.
A continuous beep sounds in TX mode.
blinks on the display.
H) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels : 40
- Modulation modes : AM
- Frequency ranges : from 26.965 MHz to 27.405 MHz
- Weather channels : 162,400 MHz to 162,550 MHz
- Antenna impedance : 50 ohms
- Power supply : 13.8 V (Mobile configuration)
7.4 V (Handheld configuration)
- Dimensions inches : 5.98 (H) x 2.62 (W) x 1.46 (D)
mm : 152 (H) x 66.5 (W) x 37 (D)
- Weight without antenna : 0.67 lb with battery pack
305 g with battery pack,
- Accessories supplied : See page 2
2) TRANSMISSION
- Frequency allowance : +/- 200 Hz
- Carrier power : 4 W
- Transmission interference : inferior to 4 nW (- 54 dBm)
- Audio response : 300 Hz to 3 KHz
- Emitted power in the
adjacent channel : inferior to 20 µW
English