Operation Manual

14
b) Direct access to one of the memories, Initial configuration Channel 3 LSB.
- Rapid depression of «PROGRAM»
appears in the display.
- Depression of «M1»The information in
is called up and the set
automatically goes to the memorised channel (CH 22 FM in our example
above).
- Rapid depression of «PROGRAM»
appears in the display.
- By pressing «M3» the information in
is called up and the set
automatically goes to the memorised setting (CH 23 FM in our example
above).
24)SCAN:
This function allows you to “scan” all the memorised channels (16). Scanning
stops when a signal is detected on one of the memorised channels. At the end
of the signal, scanning continues. By going into transmission mode you may
communicate with your correspondent and your CB leaves the scanning
mode.
This function is activated by depressing the SCAN key and «SCAN» appears in
the display. The level of the signal is defined by using the squelch button. To
cancel, depress the same key, «SCAN» disappears from the display.
25) 6-PIN MICROPHONE PLUG:
This plug is situated on the front panel, thereby making it easier to set the
equipment into the dashboard. See the cabling diagram on page 21.
26)PTT (push to talk):
Depress this knob to transmit a message and release to listen to an incoming
communication.
A) DC-POWER TERMINAL (13,2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL S-METER JACK (Ø 2,5 mm)
D) EXTERNAL SPEAKER JACK (8 W, Ø 3,5 mm)
E) PA SPEAKER JACK (8 W, Ø 3,5 mm)
C) PROTECTION BY SECURITY CODE SYSTEM:
REMINDER : Your radio CB is automatically protected by a personal 4-digit
access code (security code system) which must be re-entered in the following
circumstances: