Operation Manual

32
A “Beep” sounds each time the channel/frequency changes if the BEEP
function is activated (see KEY BEEP function page 33).
In MENU status, the s/t keys allows to select menu.
11) LCD
Indicates transmission
Indicates that front panel keys are locked except PTT pedal
and knobs. LCD shows “Err” when locked key is pressed
Beep function activated
on TX, bargraph shows Standing Wave Ratio (SWR) and value
(see INDIC function following)
ROGER ROGER BEEP function is activated
ECHO ECHO function is activated
DW DUAL WATCH activated
10K Frequency +10K function is activated
NB NB filter activated
ANL ANL filter activated
HI-CUT HI-CUT filter activated
EMG The emergency channel 9 or 19 activated
SCAN SCAN function activated
Automatic Squelch Control activated
VOX VOX function activated
MEM Memorised frequency is selected
DCS DCS code is used
CTCSS CTCSS tone is used
AM AM mode selected
FM FM mode selected
USB USB mode selected
LSB LSB mode selected
CW CW mode selected
PA PA (Public Address) mode selected
Shows the channel number
Shows the current Band
Shows DCS code or CTCSS tone
Shows the frequency and menu values
12) INDIC ~ CALL
INDIC
(short press)
Press INDIC key (12) to display current voltage, shows as “13.8DC”in LCD.
Press INDIC key (12) again or wait for 5 seconds to disable voltage display.
In TX, press INDIC key (12) to select the feature to be displayed. LCD alter-
nates with: FREQUENCY ~ SWR ~ TOT ~ VOLTAGE. Every time the PTT pedal is
pressed, LCD shows frequency and selected feature.
CALL (long press)
Press INDIC-CALL key (12) every time to send pre-edi ting prompt voice code
calling. LCD shows “TX”. (see § CALL FREQUENCY, page ).
13) ECHO ~ ECHO SET
ECHO
(short press)
Press ECHO key (13) to enable/disable ECHO function. LCD shows “ECHO”.
ECHO SET (long press)
Press ECHO-ECHO SET key (13) to set ECHO VOLUME level and ECHO TIME.
“ECHO” blinks on the LCD.
Press s/t keys (10) on the unit or on the microphone (24) to select alternately
“ ” or “ ” on the menu list.
Ratate PUSH knob (6) to set the selected feature. There are 32 DELAY levels,
default: 10. There are 32 “TIME”, default: 1. LCD shows selected “ ”
level or selected “ ”.
Press MEM-STORE (5) key for 2 seconds to store and skip into next menu.
Wait for 5 seconds to exit ECHO SET.
14) CH9/19 ~ LOCK
CH9/19
(short press)
English